In order to connect to the Tiscali DSL network in the Netherlands, please make sure you are using the most recent firmware for your Linksys ADSL modem or gateway. Recommended firmware versions can be found in the table below.
For Instructions on Upgrading Firmware on a Linksys Router, Click here.
| Device | Minimum firmware version required |
| AG241 v2 | 2.01.0 |
| WAG54G v2 Annex-A | 1.02.0 |
| WAG54G v2 Annex-B | 1.01.17 |
| WAG54GX2 Annex-A | 1.00.6 |
| WAG54GX2 Annex-B | 1.00.3 |
| WAG54GS Annex-A | 1.00.10 |
| WAG54GS Annex-B | 1.00.7 |
| WAG200G Annex-A | 1.00.9 |
| WAG354G v1 Annex-A | 1.01.09 |
| WAG354G v1 Annex-B | 1.01.09 |
| WAG300N Annex-A | 1.01.01 |
After upgrading your firmware, follow these steps:
After upgrading your firmware, reset your modem or gateway by holding down the Reset button for approximately 15 seconds.
Access the web-based Setup utility located at http://192.168.1.1. (Type these numbers in the address bar of your favorite browser)
When prompted, enter "admin" for username and "admin" for the password.
When the Setup page appears, you will need to enter the correct settings to connect to the Tiscali network. The settings you should use are as follows:
Encapsulation: RFC1483 Bridged
Multiplexing: LLC
VPI: 0
VCI: 34
Example:
(menu style and options will vary by model and firmware version)
No comments:
Post a Comment